INTERSEAL HS – PART B (REGULAR) – L () Use; Colors; MSDS / TDS; Variant; Product Review(s). Use For immersion service, Interseal HS must be applied to surfaces blast cleaned to SSPC-SP10 or Sa PT. International Paint Indonesia. Safety Data Sheet EGA INTERSEAL HS GREY PART A Version Number 2 Revision Date 06/27/ 1. Product and . International Paint Ltd. Safety Data Sheet. EGA Interseal HS Grey Part A. Version No. 2 Date Last Revised 05/10/ Conforms to the requirements of.

Author: Dogul Maujora
Country: Russian Federation
Language: English (Spanish)
Genre: Life
Published (Last): 6 July 2004
Pages: 416
PDF File Size: 2.79 Mb
ePub File Size: 11.88 Mb
ISBN: 512-8-35168-246-8
Downloads: 35455
Price: Free* [*Free Regsitration Required]
Uploader: Kajinris

Brush Typically mils microns can be achieved Roller Typically mils microns can be achieved How to use Mixing Material is supplied in two containers as a unit. Puddles, ponding and accumulations of water must be removed. Avoid using a mixture of application methods whenever possible.


If salt water is used in the wet blast process the resulting surface must be thoroughly washed with fresh water before application of Interseal HS. Systems recommendation Interseal HS will normally be applied to correctly prepared steel substrates. Prior to paint application all surfaces should be assessed and treated in accordance with ISO Preferred application is by a suitable large tip hopper gun e.


Warning In order to achieve optimum performance on hand prepared steel, the aluminum pigmented version should be applied as a primer coat by brush to ensure thorough wetting out of the substrate by Interseal HS.

Soluble salts should be removed by fresh water washing.

Typical thicknesses will be between milsmicrons. However, it can be used over suitably primed surfaces.

In common with all epoxies Interseal HS will chalk and discolor on exterior exposure. For application to a wide variety of substrates including hand prepared rusty steel, abrasive blast cleaned and hydroblasted steel, and a wide range of intact, aged coatings.

The surface to be coated should be clean, dry and free from contamination. Be the first to write a review for this product!

Please consult International Protective Coatings for alternative recommendations. A surface profile of mils microns is recommended. Alternatively, a broadcast method of application can be used. Interseal HS is suitable for overcoating intact, aged alkyd, epoxy and polyurethane systems. Press and move to zoom.

Varnish Hybrid Water base. Surface preparation The performance of this product will depend upon the degree of surface preparation. When applying by methods other than airless spray, the required film build is unlikely to be achieved.

Mouse over image to zoom. NSF Certification is for tanks greater than gallons Typically this would apply to C or D grade rusting in this standard. Sagola or Air texture gun fitted with a mm nozzle.


It is also possible to apply to damp surfaces in some circumstances. Surface defects revealed by the blast cleaning process, should be ground, filled, or treated in the appropriate manner.

Application should then be to a suitably primed surface.

INTERSEAL 670HS – PART B (REGULAR) – 0.57L (5.63 :1)

Always mix a complete unit in the proportions supplied. Certification is for tanks greater than gallons Loose or flaking coatings should be removed back to a firm edge. Premature exposure to ponding water will cause a color change, especially in dark colors.

Once the unit has been mixed it must be used within the working pot life specified. Interseal HS can be used as a non-skid deck system by modification with addition of GMA crushed flint aggregate. Consult International Protective Coatings for further details. Dry bristle brushing will normally be adequate for accumulated dirt.