ASTM B(). Standard Specification for Nickel Plate, Sheet, and Strip. standard by ASTM International, 10/01/ View all product details. Manufacturer & suppliers of Nickel / ASTM B Plate Aesteiron Steels leading Nickel / ASTM B Plate manufacturers, founded in Buy ASTM B() Standard Specification for Nickel Plate, Sheet, and Strip from SAI Global.
|Published (Last):||22 February 2014|
|PDF File Size:||10.10 Mb|
|ePub File Size:||4.86 Mb|
|Price:||Free* [*Free Regsitration Required]|
Nickel /Nickel (UNS NO, UNS NO, ASTM B)
Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard.
Offer on Fasteners Sitemap. Test methods chemical analysis, mechanical test, grain size test shall be performed in 1b62 to referenced ASTM documents itemized herein.
In plate products, this can be achieved by controlling the finishing temperature in hot rolling and the elimination of the anneal that follows hot rolling. The material shall conform to the chemical requirements for nickel, copper, iron, manganese, carbon, silicon, and sulfur.
Historical Version s – view previous versions of standard. The material shall conform to the mechanical property requirements for tensile strength, yield strength, elongation, and Rockwell hardness.
Siddhagiri Metals and Tubes B62 The material shall be uniform in quality and temper, smooth, commercially straight or flat, and free of injurious imperfections. These sheets are made by rolling process. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
Nickel 200® & Nickel 201®
ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date. Sheet and Strip can be cold rolled to higher strength. AlloyAlloy Brand: It is informational only and not an official part of the n162 the full asrm of the standard itself must be referred to for its use and application. Cutting is used to separate large sheets into smaller pieces, to cut out a part perimeter, or to make holes cavities in a part. This abstract is a brief summary of the referenced standard.
Sheet metal parts are characterized by high strength, good dimensional tolerances, good surface finish, and relatively low cost.
ASTM B – 93ae1 Standard Specification for Nickel Plate, Sheet, and Strip
For deep drawing and spinning quality sheet and strip, the material shall ast to specified values for grain size and hardness properties. Looking for some more information? Also Each flat rolled product owes its final properties not just in the rolling process itself but to its vital interactions with the preparatory steps of alloying, casting, scalping and pre-heating; intermediate annealing; and such later finishing steps as a solution heat treatment or final annealing, stretching, leveling, slitting, edge trimming and aging.
Deep drawing is a manufacturing process that is used extensively in the forming of sheet metal under tensile aastm compressive conditions, without altering the sheet thickness.
Link to Active This link will always route to the current Active version of the standard. Siddhagiri Metals and Tubes Rating: